MESH circular requirements

This topic describes the specification requirements for circular mesh (MESH) components.

Parameter description requirements

• Parameter #1 = Width of arrive

Data set requirements

For information about data set requirements that apply for all circular components, refer to Circular component requirements.

The following requirements are in addition to the data references that are created for parameters.

** Where the Default value is set to a parameter, the Expression value must be set to the same parameter. This is applicable for all component types.

P-point requirements

For information about P-point requirements that apply for all circular components, refer to Circular component requirements.

P-point P2 has Connection Type (PCON) set to OPEN because meshes are closing components and no inline component can be added after them.

The position of P-point P2 is not important, but must be included.

The following table shows the additional required P-points:

The P-points are arranged as shown in the following graphic:

Specification requirements

The following specification headings are required:

• Type (TYPE)

• Duct Shape (PSHA)

• Duct Width (PWID)

• Duct Height (PHEI) = 0

  Note:
  This type of component does not exist in the AVEVA supplied catalogue for rectangular HVAC.