Manual creation of start/end points consecutively (S1, S2, …, Sn, E1, E2, … En)
- Last UpdatedDec 15, 2025
- 2 minute read
For Manual creation of start/end points consecutively, select multiple start positions, followed by the corresponding end positions. They must be selected in the same order as the defined start positions.
-
Select the + button.
Select the down arrow in Select start element or and then consecutive selection.
-
Select equipment nozzles with unconnected end or P-points equivalent for it to be labelled in order.
-
Select the down arrow in Set start point or, then select Set ends to set the end positions.
-
When you select the first end position it will link up to the first start position and create a new branch. This will continue until all end positions are defined.
