Single to Beam Hanger

Creates a single to beam hanger from a selection in the Hangers to Steelwork gallery.

The single to beam hangers in the Supports application are used for supporting pipework using a single hanger connected to a single structural section. A default set of hanger templates are supplied with the Supports application.

You can create steelwork hangers using a combination of hanger types and ancillaries, you are guided by a series of prompts throughout the creation process.

For example, to create a FH T1 M1 B6 fixed hanger, on the Hangers to Steelwork gallery, click Single to Beam.

You are prompted to Identify tube of datum pipe or support

Note:
The prompt does not display if the pipe to be supported is already selected.

Click to identify the pipe to support using a cursor pick in the 3D view.

You are then prompted to Identify steelwork member to connect hanger to

Click to identify the supporting steelwork section using a cursor pick in the 3D view to display the Template Hanger Creation window. Refer to Template Hanger Creation for further information

Select FH T1 M1 B6 - Fixed Hanger NPS 3 - 24 on the Template Hanger Creation window and click OK to display the Support Editor window.

Click Cancel to discard any changes and close the Template Hanger Creation window.

The functionality of the Support Editor window is explained. Refer to Support Editor for further information.

The new SUPPO, SUPC and HANG elements are added to the owning ZONE and display in the Model Explorer.