STRT circular requirements

This topic describes the specification requirements for circular straight (STRT) components.

Parameter description requirements

• Parameter #1 = Width

Data set requirements

For information about data set requirements that apply for all circular components, refer to Circular component requirements.

For The following requirements are in addition to the data references that are created for parameters.

*Default value of LENG is customer specific and should be set to the standard supply length. Length can be edited in the component editor in the Model module. The No. property can be set to any value, and the other property values set as shown in the following graphic.

A data element with Key set to LENG is required for gap manager to function correctly in the Model module.

** Where the Default value is set to a parameter, the Expression value must be set to the same parameter. This is applicable for all component types.

P-point requirements

For information about P-point requirements that apply for all circular components, refer to Circular component requirements.

The following table shows the additional required P-points:

Specification requirements

The following specification headings are required:

• Type (TYPE)

• Duct Shape (PSHA)

• Duct Width (PWID)

• Duct Height (PHEI)= 0

Specific Type (STYP) is not required but is used in AVEVA supplied SIMDUCT specifications.