Draw Rectangle with Specified Corners and Set Fillet Radius
- Last UpdatedJan 23, 2023
- 2 minute read
Draws a rectangle with specified corners and a set fillet radius.
You are prompted to Specify the first corner or <Centre>
Input F at the prompt and press Enter.
You are then prompted to Specify the fillet radius <#mm>
Input a value in the dimension field and press Enter. The radius is applied to all rectangles drawn in the session.
You are then prompted to Specify the first corner or <Centre>
Click to identify the first corner of the rectangle.
Input values in the dimension fields and press Enter or click to identify the first corner of the rectangle.
You are then prompted to Specify the opposite corner or
Input values in the dimension fields and press Enter or click to identify the opposite corner of the rectangle.
The rectangle is drawn and the command ends automatically.
Throughout the rectangle creation process you can press ESC to cancel the command. Additional functionality is also available.
|
|
|
|
Fillet |
Press the down arrow key and select Fillet to set the fillet radius of the corners. |
|
Centre |
Press the down arrow key and select Centre to draw a rectangle with a specified centre point. Refer to Draw Rectangle with Specified Center Point for further information. |
|
Back |
Press the down arrow key and select Back to undo the last action. |
The new NOTE element displays in the Draw Explorer containing a RECT element.
