Create Rectangle Negative Extrusion with Two Specified Points
- Last UpdatedMar 15, 2024
- 3 minute read
Creates a rectangle negative extrusion with two specified points.
You are prompted to Select panel
Note:
The prompt does not display if the panel is already selected.
Click to identify the panel using a cursor pick in the 3D view.
You are then prompted to First corner (Surface: #, Depth: #mm) or
Input values in the dimension fields and press Enter or click to identify the first corner position.
You are then prompted to Second corner (Surface: #, Depth: #mm) or
Input values in the dimension fields and press Enter or click to identify the second corner position. A rectangle negative extrusion is created and displays in the 3D view.
Throughout the negative extrusion creation process you can press ESC to cancel the command. Additional functionality is also available.
|
|
|
|
Reference Point |
Press the down arrow key and select Reference Point to define a reference point from which the first extrusion point is measured. You are prompted to Reference Point or Input values in the dimension fields and press Enter or click to identify the reference point position. |
|
Depth |
Press the down arrow key and select Depth to define the depth of the negative extrusion. You are prompted to Specify the Depth <#> The default depth value is identical to the associated panel thickness. Input a dimensional value in the field and press Enter to set the depth of the negative extrusion. |
|
Surface |
Press the down arrow key and select Surface to define the surface position of the negative extrusion. Input a justification value in the field and press Enter or press the down arrow key and select a justification value. |
|
Fillet |
Press the down arrow key and select Fillet to create a negative extrusion with a specified fillet. You are prompted to Specify the Fillet <#> Input a dimensional value in the field and press Enter to set the fillet of the panel. |
|
Top |
Press the down arrow key and select Top to create a negative extrusion aligned to the top of the associated panel. |
|
Bottom |
Press the down arrow key and select Bottom to create a negative extrusion aligned to the bottom of the associated panel. |
|
Back |
Press the down arrow key and select Back to undo the last action. |
The new PLOO and PAVE elements display in the Model Explorer.
Refer to Non-Routed Item for further information.