Head and Tail Positioning by Bottom or Top of Pipe
- Last UpdatedFeb 19, 2025
- 2 minute read
Keywords
BOP TOP INFRONT BEHIND ONTOP UNDER
Description
This command allows the Head or Tail of a Branch to be moved vertically to a specified clearance above or below a Design element or Point. If the Head or Tail Tube has been selected, then its cross-section will be taken into account. (Otherwise the HPOS or TPOS will be moved to the specified clearance, as no Tube geometry is available.)
Example |
|
|---|---|
|
BOP ONTO /BEAM(At the Head) |
This will position the Tube on top of /BEAM with a clearance of 0. |
|
TOP UNDER U3000(At the Tail) |
This will position the Tail under the elevation U3000 with a clearance of 0. |
Note:
If no Tube can be found emerging from the point specified, then only the point’s position
can be used.
Command Syntax
>--+-- BOP --.
| |
‘-- TOP --+-- <uval> --.
| |
‘------------+-- FROm --.
| |
|-- TO ----+-- <bpos> -->
|
|
|-- INFront --.
| |
|-- BEHind ---|
| |
|-- ONTop ----|
| |
‘-- UNDer ----+-- <gid> ---.
| |
|-- <marke> --|
| |
‘-- <bpos> ---+-->
Querying
>-- Query --+-- PHead ------.
| |
|-- PTail ------|
| |
|-- HTail ------|
| |
|-- HHead ------|
| |
|-- HPosition --|
| |
‘-- TPosition --+-->
Head/Tail positioning by Bottom/Top of pipe