Combined Pipework Tolerance and Tube Length Options

Keywords

TOLERANCE OPTIONS DEFAULT

Description

The OPTIONS command allows the user to reset defaults for, or query, all data consistency checking options for Tubes at the same time.

Command Syntax

>-- TOLerance OPTions DEFault -->

Querying

>-- Query TOLerance OPTions -->

Outputs the current settings for all data checking parameters. The parameters are output in the current units.

Querying Examples

With all default settings in force, the output resulting from a Q TOL OPT command will show one of the following sets of values (depending upon the current units):

MM Bores and Distances

Minimum tube length : 100 mm
Tolerance Offset    : 1 mm
Tolerance Angle     : 0.0573
Tolerance Ratio     : 0.001
Maximum Angle       : 90
Atta checking       : ON

INCH Bores and Distances

Minimum tube length : 3.9 in
Tolerance Offset    : 0 in
Tolerance Angle     : 0.0573
Tolerance Ratio     : 0.001
Maximum Angle       : 90
Atta checking       : ON

FINCH Bores and Distances

Minimum tube length : 3.15/16
Tolerance Offset    : 0.1/32
Tolerance Angle     : 0.0573
Tolerance Ratio     : 0.001
Maximum Angle       : 90
Atta checking       : ON