Select the Pump record command state

The Pump Command State dialog allows you to define a command that will be executed on the configured status or multistate point when a Run or Stop command is issued in easy eXtended Operator Station (ezXOS). The dropdown list is populated with all possible commands that are configured on the point that has been selected in the Path field. When a Controller attempts to execute a run or stop command from ezXOS, the command in the Command Run or Command Stop field will be executed on the telemetered point.

To select the pump record command state

1. In the Command Run or Command Stop field, select (...).

   The Select Command State dialog appears.

   

2. Select OPEN or CLOSE from the dropdown list to set the pump command state.

   Notes: The available commands are based on the output command base message set from the associated status or multistate point. If an output command base message set is not configured for the status or multistate point, the configured base message set is used.

   If the command base message is configured, the maximum number of values in the message set is eight. In situations where the command base message is not configured, it will use the base message in the Select Command State dialog, which, for its message set, has a maximum possible number of values of 32.

3. Select Accept.