Configure the Inhibits tab of the Meter Prover record

There are a number of situations that can cause the meter proving application to raise an alarm. However, it is possible to inhibit some of these situations based on the needs of your organization.

To inhibit unnecessary alarms and events

1. To inhibit the alarm that occurs when a detection is aborted, select the Alarm Inhibited checkbox.

2. To assign the severity of this alarm and event, select one of the following options:

   • low

   • minor

   • medium

   • major

   • high

   • critical

3. To inhibit the alarm that occurs when an end-of-run (EOR) detection is aborted, select the Alarm Inhibited checkbox.

4. To assign the severity of this alarm and event, select one of the following options:

   • low

   • minor

   • medium

   • major

   • high

   • critical

5. To inhibit the alarm that occurs when a pump has been aborted, select the Alarm Inhibited checkbox.

6. To assign the severity of this alarm and event, select one of the following options:

   • low

   • minor

   • medium

   • major

   • high

   • critical

7. To inhibit the alarm and event that occurs when the Controller aborts the meter prove, select the Alarm Inhibited checkbox.

8. To assign the severity of this alarm and event, select one of the following options:

   • low

   • minor

   • medium

   • major

   • high

   • critical

9. To inhibit the alarm that occurs on a sequence start or completion, select the Alarm Inhibited checkbox.

10. To assign the severity of this alarm and event, select one of the following options:

    • low

    • minor

    • medium

    • major

    • high

    • critical