AVEVA™ Unified Engineering

Endcut properties

Save PDF

Save PDF

Use the properties to add or modify the endcut and bevel-related properties under the Geometry section of the Properties window.

By default, the Endcut value is set to unset.

The following table defines all the endcut properties.

Endcut	Defines the endcut properties for the selected element.
Cutting plane type	Specifies the type of endcut. By default, the value is Undefined. Undefined – No endcut is applied. Built-in – Uses a predefined endcut.
Designation	Specifies the designation value.
Functional type	Specifies the functional classification. By default, the value is Undefined.
Spacing type	Specifies the spacing definition. By default, the value is Undefined. Undefined – No spacing type is applied. Gap – Specifies the gap between the stiffener end and the limiting element, measured along the profile trace. Overlap – Extends the profile beyond the limiting model in the tangent direction of the trace. Tight – Connects the profile end tightly to the limiting model.
Size of spacing	Specifies the spacing size in mm.

When you define an Endcut, the following properties become available. For more information, see Define endcut properties.

By default, the following properties are set to these values:

Excess is set to 0mm

The following table defines all the bevel properties.

Bevel on Web	Specifies the bevel code for the web.
Bevel on Flange	Specifies the bevel code for the flange.
Excess	Specifies the excess area defined for an element.

When you define a Bevel Code, additional properties—similar to Endcut—become available. For more information, see Define bevel code.

The following table defines all the additional bevel properties:

E-measure

Specifies the project unit of measurement in mm.

Side

Specifies the side.

Variant

Displays the variants applicable to the selected bevel code. By default, the value is V0.