Seam Bevel / Excess Creation window
- Last UpdatedJun 08, 2026
- 2 minute read
It defines bevel geometry and excess values for the two sides of a seam and apply the defined settings to selected seams.
Bevel
Defines the bevel applied to each side of the seam.
Bevel checkbox
Enables or disables bevel definition.
Side A/ Side B
Specifies the bevel code for each side of the seam.
Search icon
Displays the bevel selection list to choose a valid bevel code.
Link control
Allows the same bevel to be applied to both sides.
If disabled, then each side can have a different bevel.
Side A Bevel Details / Side B Bevel Details
Displays information about the selected bevel.
Diagram
Displays a graphical representation of the bevel geometry, including angle Alpha, Beta, Nose Len A, Nose Len B, Gap, and radius values.
Parameters
Displays the properties of the selected bevel, including Type, Name, Alpha, Beta, Gap, Nose, and Nose Length A.
Note: These values are derived from the selected bevel and cannot be modified in this window. The application derives these values from the selected bevel code.
Excess
Defines additional material allowance for each side of the seam.
Side A Excess
|
Excess Type |
Specifies the excess type. Selection depends on the excess standards defined in Paragon. |
|
Excess Value |
Specifies the excess amount for Side A. |
Side B Excess
|
Excess Type |
Specifies how the excess is applied for Side B. |
|
Excess Value |
Specifies the excess amount for Side B. |