Label Types tab
- Last UpdatedJun 25, 2026
- 1 minute read
Defines the label types for predefined element types.
Checkbox
Defines which labels to apply to the selected Part Types.
Select a checkbox to apply the corresponding label type:
|
Sets the Part label predefined in the Part Details tab. |
|
Sets the Direction label predefined in the Production - Directions - Guide Diagram table. |
|
Sets the Bevel label predefined in the Bevel Label Set. |
|
Sets the Excess label predefined in the Production - Excess Label. |
|
Sets the Marking label predefined in the Marking - Guide Diagram. |
Note: Select at least one label type.
Height(s)
Defines the label heights.
Enter a single value with a length unit.
To specify multiple values, enter a comma-separated list with a space after each comma (for example, 10 mm, 8 mm, 6 mm). When you enter multiple values, the application checks whether the label fits on the part. If the largest height does not fit, the application uses the next smaller height.
omissible
Specifies whether to omit a label when there is not enough space on the part.
Select the checkbox to omit the label if none of the defined heights fit on the part.