Configure status and multistate points

Follow this procedure to make status or multistate point alarms re-alarm a set number of minutes after you acknowledge them.

Note: In the following procedure, a status point is used as an example. The procedure is the same for configuring multistate points. The Status Control dialog box is opened through the Status Summary window. For information on the Status Summary window, refer to the AVEVA Enterprise SCADA HMI Controller documentation.

To configure status and multistate points

1. Navigate to the Status Control dialog box.

   

2. In the Realarming Time(Min) field, enter the number of minutes after which an acknowledged alarm should re-alarm.

3. Select Submit.