Way of Presenting Single Measurements

These are as follows:

1. Text inside, both arrows inside

2. Text inside, both arrows outside

3. Text outside, one arrow inside and the other outside

4. Text outside, both arrows outside

5. Mold line dimensioning. This presentation is specific for symbolic hull views. The presentation is similar to (1) above, but considering the mold line of hull components. The measurements are calculated from the actual mold line of the cross section of a hull component instead of from one of the edge contours. The dimensioning arrows are then placed at the mold line on the opposite side of the material. If the mold line does not coincide with any of the sides two dimensioning arrows are set in opposite directions, both located at the mold line.

Keyword: DIM_LIN_PRES