ITEMCODE (1)

Function:

Allows you to label certain types of fitting with their itemcodes on the isometric drawing.

Description:

By default, itemcodes for piping components are shown only in the material list.

For in-line fittings of generic types INST, VALV, FILT, PCOM, TRAP or VENT, you can specify that itemcodes are also shown against the corresponding component symbols on the isometric plot.

You can also specify that itemcodes are not to be shown at all.

Examples:

ITEM INST TRAP ON

Itemcodes for Instruments and Traps shown against plotted symbols and in material list; codes for all other component types shown in material list only.

ITEM TRAP VENT OFF

Itemcodes for Traps and Vents not shown at all; codes for all other component types shown in material list only.

ITEM ALL ON

Itemcodes for all valid component types shown against plotted symbols and in mate Itemcodes for all types of component shown in material list only.

ITEM OFF

Itemcodes are shown only in the material list.

Related Commands:

TAGGING

Command Syntax:

                  .--------<--------.
                 /                  |
>--- ITEMcode ---*--- fittingtype --|
                 |                  |
                 ‘--- ALL ----------+--- ON --------.
                                    |               |
                                    |--- OFF* ------|
                                    |               |
                                    ‘--- DEFault ---+--->

where fittingtype is any of INST, VALV, FILT, PCOM, TRAP, or VENT.

Querying:

Q ITEMCODE
Q OPTions