Removing Elements from the Display
- Last UpdatedNov 14, 2025
- 1 minute read
Keywords:
REMOVE
Description:
These commands remove elements from the Draw List and the display.
|
Examples: |
|
|---|---|
|
REMOVE ONLY /VESS1/N1 |
removes only nozzle /VESS/N1 from the 3D view |
|
REMOVE /BRANCH1 |
BRANCH1 will be removed from the Draw List and the display |
|
REM SITE /PIPING |
The site /PIPING will be removed |
|
REM ALL |
All items in the Draw List, and on the screen, will be removed |
Note: If an element below a significant element (that means, a primitive) is removed, then the whole significant element will be removed as well. To avoid this behavior the Remove ONLY command should be used. REMOVE ONLY will not remove the significant element but only remove the given primitive from the 3D view (the primitives that have been added/removed can be seen on the primitives tab of the drawlist form). (Note: if the element being added/removed is significant or above a significant element then ADD/REMOVE ONLY will have the same effect as ADD/REMOVE).
Command Syntax:
>-- REMove --+-- Only --+
| |
‘----------+ -- <selatt> ------>