Replace Statement
- Last UpdatedDec 12, 2023
- 1 minute read
Contrary to AVEVA Marine Hull the alternative standard differentiates between endcuts with and without calculated endcut angles. for example, a simple endcut 1100 is corresponded by endcut string A, whereas 1100, 60 is corresponded by for example, Cb125 (cf. above). Since you do not know beforehand if the connection angle is 90 degrees or not (in case of a connected profile end) the user may preliminary select a C-type endcut. If the connection angle should happen to be 90 degrees the resulting endcut should be replaced by Ca0.
The REPLACE statement will allow the customer to specify that an initial part of the endcut string may be replaced by another string.
Syntax:
|
REPLACE, <prefix> |
||
|
/ BY = <exch_str> / WHEN = <TB_type1> (1....10) ; |
||
|
<prefix> |
The initial part of an endcut string that, if found, should be exchanged. |
|
|
BY |
Specifies the string, by which to exchange. |
|
|
WHEN |
This replacement should occur only when the corresponding AVEVA Marine endcut type is <TB_type>. WHEN is the 2 or 3 digit endcut type. Maximum 10 types can be given. |
|
Examples:
REPLACE, Ca0 /BY = A / WHEN = (11, 21);
REPLACE, Ca0 /BY = B / WHEN = (12, 22);