Wall and Floor Specification

Both the walls and floors specification can be set so that a range of thicknesses or an explicit thickness can be used. As walls and floors do not have catalogue items the Specification Reference does not have a Catalogue Reference and the selected thickness may be overwritten when the wall or floor is created. The specification may be left unset and the thickness specified during wall or floor creation.

The default wall or floor specification is shown in the Walls and Floors toolbar. The Default Specification is shown unset.

1. Click Set Wall Default Specification in the Walls and Floors toolbar to display the Wall Specification (Default) window.

   

   The Specification Data area enables a specific profile to be set as default.

   The Pline Settings area of the window enables these attributes for the chosen profile to be set:

   • Justification - Sets the justification of the wall with the Pline names.

   • Member Line - Sets the position of the line displayed in Draft, for example, the centre line.

   • Joint Line - sets the pline for joint geometry (normally NA).

     

2. Click Properties to display the Modify Properties window where the thickness and height of the wall are set.

3. Click Apply in the Wall Specification (Default) window to set the wall specification.

   The wall specification is shown in the Walls and Floors toolbar.

4. Click Dismiss to discard any information and close the Wall Specification (Default) window.

5. Click Set Floor/Screed Specification in the Walls and Floors toolbar to display the Floor/Screed Specification (Default) window.

   

6. Click Specification to select the default panel specification.

7. After selection of the default Panel specification, Floor Specification or Screed Specification, you can select the default thickness from the displayed list.

8. Select unset and the specification is not set.

9. To set the specification and default thickness, click Apply.

10. Click Dismiss to discard any information and close the Floor/Screed Specification (Default) window.