Bevel Type 41

This bevel is an asymmetric variant of the bevel type 40. The asymmetry means that the opening angles on both sides of the bevel may be different and that the position of the nose must be defined. This is done as the distance (H) to the lower edge of the nose from the negative side, cf. the figure below. Apart from these differences the pictures for bevel type 40 are applicable

Figure 1:18. Bevel type 41.

Relevant parameters: a, b, NOSE, H, GAP

H may be given as one, two or three values: H = ( h, hf, hAdjust).

The second value is interpreted as a factor and H will be given the value MAX (h, hf*E).

If hAdjust is given, the H is adjusted and given the value H + hAdjust.

If NOSE=N (0<N<1) then the nose height will be calculated as NOSE=N*E.

In both cases E is the e-measure as defined in 18.3.1.