Selection of a Certain Profile

When picking a certain occurrence of the profile types described in this specification it is normally enough to give the nominal height. Sometimes two different profiles may have the same nominal height and in that case a second parameter must be given as well (= the flange width). The given parameters will always be replaced by the closest occurrence in the table.

However, there is an option to give all the parameters via input. The given parameters will then be used as given. This can be done regardless of if SBH_I_U_BARS has been set or not. The parameters must be given in the order of the parameter statement as specified above.

Note that the flange angle cannot be affected in this case. The default angle of the DIN-standard will be used (when relevant)).