Bevel Information in Production Output

The bevel information is output in direct production control in different ways, for example,

• From the nesting system the bevel information is converted to burning contours, to burner angles, offsets, The information may be output in burning sketches in a similar way as described for bevel notes in drawings (however, just as text strings, see NEST_TEXT above) but also in for example, the generic format for plate cutting.

• For profiles the bevel information may be output in lists and in generic format for profile fabrication.

Common for this information is that whereas the bevel information within AVEVA Marine is based on occurrences of basic bevel types these references are in the output format resolved and replaced or completed by explicit parameters related to a generalised section of a bevel, for example, as in the picture below (the parameter B is never stored, since it can always be calculated from the other parameters)

.

Figure 1:65. Generalised bevel section.