PROFILE Statement

PROFILE,   <type>

           /VIEWING = <viewcode>

           [/PLANE_SYMBOL = <symb_No>]

           [/CROSS_SYMBOL = <symb_No>]

            [MDIST=<distance>]

            [MSIZE=<length>]

            [MGAP=<length>]

           ;

<type>

The number by which this type of swage is selected. It must be in the interval 100-110.

VIEWING

A code for the line types that should be used to represent swaging in planar views of swaged panel. For allowed values, see above.

PLANE_SYMBOL

Symbol to be used together with the line(s) in planar views of swaged panels. For allowed values see above. If this attribute is left out then no symbol will be set.

CROSS_SYMBOL

Symbol to be used together with the line(s) in section views of swaged panels. For allowed values see above. If this attribute is left out then no symbol will be set.

(Is becoming obsolete for new swage handling).

MDIST

Optionally it is possible to get extra markings at both sides of the symmetry line of the swage at the edges of the plate. MDIST specifies the distance of these from the symmetry line. See figure below.

MSIZE

Length of extra marking (right figure below).

MGAP

Length of marking gap at boundary (right figure below).