Bevel Type 16
- Last UpdatedDec 03, 2025
- 1 minute read
This is a completely tight joint with a full fitting (the figure shows a negative CON)
Figure 1:40. Bevel type 16.
A connection angle not equal to zero will result in a V-shaped bevel.
Relevant parameters: a, GAP
Varying parameter: a
|
CON>0: |
The bevel should be turned so that the positive side is turned downwards. |
|
CON<0: |
The positive side should be turned upwards, see the figures below. |
This means that a = -CON
Figure 1:41. Side selection depending on connection angle.