Control Information for Normal Bending Templates

The run mode described in this document is activated by the presence of the default keyword NORMAL_TEMPLATES (see below). The following information is relevant in the default file:

ENGLISH,

DISTTOEDGE, <dist>,

MAXDISTTOTEMPLATE, <dist>,

MINHEIGHTOFTEMPLATE, <height>,

PINS, [<dist>,]

For details about these words above, see the main part of the document.

FRAMETEMPLATES,

This word states, that the program always shall create frame templates. If this word is given, the next one - NORMAL_TEMPLATES - is not taken into account. Thus, giving this default will inhibit the run mode described in this document.

NORMAL_TEMPLATES, [MANDATORY,]

This word states, that the program is allowed to choose between frame templates and Normal Templates. The transition takes place at the angle 75 degree. If the parameter MANDATORY is given, the program is told to always create Normal templates.