Notch at Distance
- Last UpdatedDec 04, 2025
- 1 minute read
Notches are given at given distances from any of the ends of the given stiffener.
|
<notch_at_distance>::= D= <dist> (1 ... 25) <S-ref> (1 ... 25) |
||
|
D |
is the distance from any of the end points of the stiffener. |
|
|
> 0 |
from the starting point. |
|
|
< 0 |
from the ending point. |
|
|
<S-ref> |
Tag references are not allowed when notches are set in this sub-syntax. |
|
If any of the given distances should lie outside the stiffener, the corresponding notch will be shipped without notification.
|
Example: |
|---|
|
NOT, R30, SEAM=1-3, SL1-10; NOT, R25, D=50(300)4000, S1-5; NOT, R35, X=FR75.5()85.5, SL1, SL3; |
Note: The syntax is very powerful and a large number of notches can be set in a large number of stiffeners in one statement. For example, in the last example above, several different stiffeners with longitudinal tag numbers 1 and 3 may be intersected by the given lines.