Branch Connectors Components - Circular Mitred c

The task of creating an HVAC Component is initiated from the HVAC Window.

1. Select Branch Connectors in the Categories drop-down list and then CIRCULAR miterd c in the Available Type drop-down list to display the Mitred Brconnector window:

   

   The user is required to input the following dimensions:

   • Brco Diameter

   • MAIN width LA

   • MAIN depth LB

   • Brco Length

   • Dist from Leave

   • B offset

   • Brco Extension

   • Fixing to Duct

   • Male Collar

   • Inner Extension

2. To visualize how the dimensions equate to the actual piece of HVAC, click Picture to display a detailed drawing for Branch Connectors Catalog Element - Circular Mitered.

   Note: The fields will be pre-populated with default dimensions. These dimensions are governed by the details defined in the HVAC Catalog. The Brco Extension default is auto but can be changed by the user to a required dimension. The Fixing to Duct joint default is joint defined in the HVAC Catalog but can be change by the user to the required joint.

3. Click Transpose width/depth to exchange MAIN width LA dimension with MAIN depth LB dimension.

4. Specify a type of joint to use for the Brco Jnt (Brco Joint). Refer to Create HVAC Component for a detailed description.

5. After selecting the type of joint to use for the Brco Jnt, the user must enter the Brco Direction.

6. In Brco Direction specify axis that should be used. Valid axes are E (East), N (North), U (Up), -E (negative East), -N (negative North) or -U (Negative Up). X, Y, Z, -X, -Y or -Z.

7. In the Connect list, select Connect or Unchanged:

   • Click Connect (default when Create is selected) - connects the piece of HVAC to the previous one.

   • Click Unchanged (default when Modify is selected) - positions the piece of HVAC at the co-ordinates 0.00.

   Note: Unchanged is usually used, when Modify is selected, it does not connect the piece of HVAC but positions it at 0.00, in effect in a floating position.

8. Click Defaults to reset all the fields back to when the miterd Brconnector window was opened.

9. Click Fit To Next to orientate the miterd Brconnector to automatically fit this piece of HVAC to the next piece.

10. Click OK to create the miterd Brconnector component and close the miterd Brconnector Window. The user will be returned to the Create HVAC Component.

11. Click Cancel to discard all field changes and close the miterd Brconnector window.