Auto

Based upon the scope that is currently defined, you can create an input file to be used along with autopos, optionally start it as well. This will then automatically set position numbers for the plane panel parts within the current scope.

Additional information that is required at runtime is possible to specify in the form that follows. For further details, see also the Auto Generation Number Setting documentation.

Within this form it is possible to specify:

• The case to be used (if more than one specified)

• Prefix and suffix strings, if any

• Part types to be dealt with

• Types of already existing position numbers that should be updated

• Whether or not position numbers should be updated

• Scope subdivision when comparing parts

The scope is taken as currently defined.

After filling in the relevant information, you can either:

• Exit from the function with no position numbers updated (Cancel)

• Create the input file and start autopos with the file as input (OK)

• Reset all fields to the initial value (Clear)