Report Editing - Report Order Tab
- Last UpdatedDec 18, 2025
- 2 minute read
Report Editing - Report Order Tab
Elements
This page may be used to reorder and/or remove elements from the report:
An element can be any one of the following
-
Text
-
Table
-
Graph
-
Page Break
-
Open GL diagram
-
Polar Diagram
Add
Is used to move elements from the Possible list to the Required list (that is, reintroduce any previously removed elements).
Remove
Is used to move elements from the Required list to the Possible list (that is, remove them from the report).
Up
Is used to move an element up the report.
Down
Is used to move an element down the report.
Additional Elements
Currently, two additional types of elements may be added to the report:
|
Page Break |
User defined page breaks may be added to the report and then moved as normal using the Up and Down buttons as described above. Note: |
|
User Text |
single blocks of text may be added using this button. You need to simply enter the required text into the edit box next to this button (the User Text button will be enabled) and then click the User Text button. The text will be appended to the end of the Required list. It can then be reordered in the usual way. |
Justification
By default, reports are center justified within Hydrostatics/Hydrodynamics. Justification can, however, be changed by clicking the Left, Centre or Right buttons.
Note:
Justification applies to the entire report, not to single elements.
Reset
This resets the element ordering, removes any additional elements and re-centers the justification. Thus the report will look the same as the Hydrostatics/Hydrodynamics default.