Please ensure Javascript is enabled for purposes of website accessibility
Powered by Zoomin Software. For more details please contactZoomin

Hull and Outfitting

TABLE OF CONTENTS

Catalog Versions

Save PDF
Save selected topicSave selected topic and subtopicsSave all topics
Share
Share to emailCopy topic URL
  • Last UpdatedNov 14, 2025
  • 1 minute read

During the lifetime of this application, updates to the Catalogue are quite likely. For example a typical change might be the default orientation of an unequal angle. This has been a cause of problems in the past when operating the application on both PDMS12.1 and AVEVA E3D Design.

You can perform a quick check to validate the profile orientation using the following lines either in the command window or as a macro.

NEW SITE /TestAngleOri

NEW ZONE

NEW STRU

NEW FRMW

NEW GENSEC SPRE /L100x50x10

JUSL SNFG

NEW SPINE

NEW POINSP at E0

NEW POINSP at E500

Obviously you should change the SPRE to be the profile under investigation. By comparing the view between versions the user can see if there is any difference in configuration between versions.

You must be aware that the Catalog update function might need to be changed to locate the Plines correctly according to the Cardinal Points. Refer to Technical Information - Cardinal Points for further information.

TitleResults for “How to create a CRG?”Also Available in