ELEVATION

Function:

Specifies whether or not elevation coordinates are to be shown on isometrics.

Description:

By default, elevations are shown on isometrics at all intersection points where there is a change of elevation. You can change this as shown in the following examples.

Examples:

ELEVation VERTIcal

Outputs elevations only on vertical sections of pipe (that means, linear dimensions are omitted).

ELEVation VERTical AND DIMEnsions

Outputs both elevations and dimensions on vertical sections of pipe.

ELEVation INTERsections

Resets the default condition so that elevations are only shown at intersection points where there is a change of elevation, and dimensions are shown on vertical sections of Pipe.

ELEVation 'SUPPressed'

Suppress all elevation notes.

Related Commands:

COORDINATES COORDS DIMENSIONS

Command Syntax:

>-- ELEVation --+-- INTERsections* -----------------------------.
                |                                               |
                +-- VERTical ------+-- AND --.                  |
                |                  |         |                  |
                |                  |---------+--  DIMEnsions  --|
                |                  |                            |

                |                  ‘                            +

                |                  |                            |

                ‘-- SUPPressed ---------------------------------+-->

Querying:

Q ELEVation

Q OPTions