ADD
- Last UpdatedFeb 06, 2024
- 1 minute read
Purpose
To add defining (interval) curves to the specified patch.
Syntax
|
ADD <PATCH> ($W ) (FOB) (/ALL) (FOS) ------------------------ (DIAGONAL ) ($L) (KNUCKLE ) (TANGENT ) (PLINE ) ------------------------ (BUTTOCK ) ($S) (SECTION ) (WATERLINE) ------------------------ (/NONE) |
Description
When a patch is GENERATED it is automatically assigned the current internal curve type, that means, Section, Waterline, Buttock or Deck, this means that any curve that is SWITCHed ON, is of the given type and crosses the patch should be used when OUTPUTting the patch. Using the ADD command the user may be more selective about which curves are used. The internal curves are not restricted to orthogonal curves but can be any of the curves types shown in the command syntax above. However, the curves that are added must all be consistent in their definition, that means, they should all intersect the same two boundaries of the patch.
Command Qualifiers
|
$W |
The name of the patch to be changed. Wildcards are allowed. |
|
/ALL |
All patches are changed. |
|
/NONE |
The defining curves are removed for the given patch. |