Decks, longitudinals or transverse bulkheads
- Last UpdatedDec 18, 2025
- 1 minute read
|
Record |
Meaning |
|---|---|
|
Type |
D for deck L for longitudinal T for transverse |
|
Name |
Identifier for the surface |
|
Layer |
Layer on which the surface is defined |
|
Mean position |
The mean position is an X value for a transverse, a Y value for a longitudinal and a Z value for a deck. |
|
Number of cambers |
The number of cambers must be zero for a transverse. |
|
Camber position |
X position of the camber curve |
|
Number of points |
Number of points on the camber curve |
|
Y Z |
Y value of the camber point Z value of the camber point This record is repeated for Number of Points The above 2 records are repeated for Number of cambers |
|
Boundary 1 Boundary 2 Boundary 3 Boundary 4 |
The identifiers of the bounding surfaces. If the surface is unbounded in one direction, the identifier should be * Note: |
|
Corrugation |
0 if not corrugated 1 if vertical corrugations 2 if horizontal corrugations |
|
Alignment |
0 if centered, 1 if aft, 2 if forwards. |
|
Width Height |
|
|
Angle |
In degrees |
|
Radius |
Note: |
|
Lower stool present |
1 if present, 0 if no lower stool |
|
Top width Base width Top elevation Knuckle elevation Base offset |
|
|
Top offset |
The above record is present only if Lower stool present is non zero. |
|
Upper stool present |
1 if present, 0 if no lower stool |
|
Top width Base width Top elevation Knuckle elevation Base offset |
|
|
Top offset |
The above record is present only if Upper stool present is non zero. |