Create the Second Subframework

Position the support plane for the East-West pipe run.

Move the plane through the East stanchion of the first Subframework.

Create the Subframework.

Click on the Support Creation toolbox.

The Select Section Plane form is displayed, listing the two subframeworks.

Choose the second one.

Note: The Select Section Plane form will be displayed every time you change the support in any way, so that you can select the correct subframework.

Create the template members in the usual way

Configure the support as an L-bracket.

If necessary, use the Mirror icon to orientate the template so that the unattached end is towards the first subframework.

Now modify the Support Template as in the following steps:

1. Click on the Modify Support Template form to make the anchor point on the end of the cross-member into a free end.

2. Click and extend the cross member through the Stanchion of the first support.

3. When prompted, confirm that the member should be connected.

4. Click to make the joint, picking the stanchion as the owner and the cross-member as the attached member.

5. Click and attach the anchor point to the floor.