Minimum Line Width

The MINLW parameter is configurable by the user in the DRAFT UI and via the DRAFT PLOT command; it was used to change the value of both THIN and the minimum user-defined line-style width. It applied only to the hardcopy exports (PDF, EMF etc) and did not affect DXF or AVEVA PLOT files.

It is no longer required, as the line-styles are now precisely defined. It has been withdrawn from the UI and the PDMSUI/dflts/plotter_user_defaults file where its default value was defined.

Its use with the PLOT command is deprecated: its value is ignored and a warning given if it is used.

Note:
This means that the user no longer has a way to artificially thicken thin lines on a drawing during export. This was introduced at 12.0 and was a side effect of allowing the user to determine the value of THIN line-styles.