Highlighting
- Last UpdatedOct 27, 2023
- 2 minute read
With the highlighting tab selected, the user can define the colour's used in the component list when selecting components from the list. Once a highlighting colour scheme has been defined this is restored upon re-entry into the application.
The Highlighting tab on the Modify Components window, displays:
|
Component: |
Defines the colour of the selected component in the list. |
|
Tube: |
Defines the colour of the selected tube in the list. |
|
No Specification: |
Defines the colour of the selected component in the list, when there is no specification. |
|
Successfully Selected New Specification: |
Defines the colour of the selected component in the list, when a new specification has been found. |
|
Failed to Select New Specification: |
Defines the colour of the selected component in the list, when a new specification can be found. |
|
Reset to Defaults |
Returns the highlight colours to the default setting. |
|
Apply changes to like components |
Apply the changes to similar components in the list, without the need to select them. |
To change any of the highlighted colours, click the colour to be changed to display a colour selection window.
Note:
The name of this window will change depending on which of the colours is selected
on the Modify Components window.
Note:
The colour on the Modify Components window changes to match the selection.
Select the required highlighting colour, and once set the button will change to that colour and the highlighting will be changed in the component list.
Specific highlighting can also be turned On and Off using the radio buttons next to each highlighting colour buttons.
Note:
The highlighting defaults are loaded if no highlighting scheme can be retrieved upon
entering the Pipework application.