Component Clearance Vertically
- Last UpdatedNov 18, 2025
- 2 minute read
Keywords:
CLEARANCE ONTOP UNDER
Description:
This command places the current Component on the constrained centerline at a specified vertical clearance above or below a fixed object. If the Arrive or Leave point of the referenced object is used, then the Tube cross-section emerging at this point is considered rather than the full item geometry.
|
Examples: |
|
|---|---|
|
CLEARANCE ONTO /BEAM |
The current Component will be placed on the constrained centerline at zero clearance above the specified object (see Requirements for the Thermo Library Generation Tool). |
|
CLEARANCE 50 UNDER /BEAM |
The current Component will be placed on the constrained centerline at 50 vertical clearance below the specified object (see Requirements for the Thermo Library Generation Tool). |
|
CLEAR 50 ONTO IDP @ |
The current Component will be placed on the constrained centerline at a clearance of 50 vertically above the picked p-point. If this p-point is an Arrive or Leave, then the Tube cross-section will be taken into account (see Requirements for the Thermo Library Generation Tool). |
Command Syntax:
>-- CLEArance --+-- <uval> --.
| |
‘------------+-- ONTop --.
| |
‘-- UNDer --+-- <gid> ---.
| |
|-- <marke> --|
| |
‘-- <bpos> ---+-->
Querying:
>-- Query <marke> --+-- POSition --.
| |
|-- BOP -------|
| |
‘-- TOP -------+-- WRT --.
| |
‘-- IN ---+-- <gid> -->
Figure 3:28. Component clearance above/below a fixed object