CONTNOTES

Function:

Specifies continuation notes at the end points on drawings for when the drawing continues onto another isometric (as opposed to when the drawing continues onto another sheet of the same isometric).

Description:

The note can include the name of the continuation pipe, drawing, or both, as defined by the SPOOLER module and also the contents of a pipe UDA. If the termination point on the current isometric is a weld, you can include a description of the connecting component or tube in the notes.

Examples:

CONTN PI

Continuation notes show pipe names only.

CONTN BO DESC ON

Continuation notes show both pipe and drawing names, and will include descriptions for welds of the connecting component.

CONTN PI DESC ON :CNOTE

Continuation notes show pipe names and pipe CNOTE UDA.

Command Syntax:

>- CONTNotes -+- PIpe -.
              |        |
              |- DRwg -|
              |        |
              '- BOth -+- DESCriptions -+- ON --.

                       |                |       |

                       |                |       +- :udaname -.

                       |                |       |            |

                       |                '- OFF -+------------|

                       |                        |            |

                       '------------------------+------------+-->