Bevel Type 31

This bevel type is an Y-joint with an angle defined for the nose.

Figure 1:12. Bevel type 31

Relevant parameters: ALPHA, NOSE, NOSE_ANGLE, GAP

In the picture above the angle a is defined by parameter NOSE_ANGLE and the angle a2 is defined by parameter ALPHA.

NOSE < 0 means that the height of the nose is defined as the distance from the upper surface of the plate, that means, the nose height is T -ABS( NOSE) (T is plate thickness).

If ABS(NOSE) = N (0<N<1) then the nose height will be calculated as NOSE = N * E (where E is the e-measure).

Figure 1:13. Variants of bevel type 31