Point Sets
- Last UpdatedJan 13, 2026
- 1 minute read
These have been created with the minimum points required by MDS. These are:
|
P-Point |
Description |
|
1 |
Arrive Point |
|
2 |
Leave Point |
|
3 |
Bottom of Pipe (BOP) -5mm, that means, bottom of the ancillary geometry -5mm |
|
9 |
BOP (Including geometry if required), that means, bottom of the ancillary geometry |
|
10 |
Left of Pipe |
|
11 |
Right of Pipe |
|
12 |
BOP |
The diagram below shows the position and directions of the p-points, P1 and P2 are arriving and leave points along the centerline of the pipe.
Note: The MDS default p-points provided cannot be deleted or modified, but additional p-points can be created if required.