Bevel Type 36
- Last UpdatedDec 03, 2025
- 1 minute read
Bevel type 36 is a Y-bevel where the opening angle is depending on the varying connection angle in a similar way as described for bevel type 26 above
Figure 1:45. Bevel type 36.
Relevant parameters: a, DIFF, NOSE, GAP
Varying parameter: a
|
| NOSE | <1 |
Means that NOSE is defined as factor to be multiplied by the actual plate thickness to get the height of the nose. |
|
NOSE > 0 |
Means that the height of the actual toe (the vertical (lower) part of the bevel contour), |
|
NOSE < 0 |
Means the nose height is calculated as T- ABS(NOSE) (T is the plate thickness), that means, the nose height is defined by the distance from the positive side to the knuckle point of the nose. |
|
(for example, NOSE=0.5 means that the "knee" of the bevel is in the middle of the plate) |
|
|
CON>0: |
The positive side of the bevel is normally supposed to be turned upwards (as in the figure above). |
|
CON<0: |
The positive side is turned downwards. |
This means that a = DIFF - CON