Endcut Code

Endcut codes are instances of endcut types with a certain combination of standard values for the implicit endcut parameters. The endcut codes of a certain endcut type have always numbers, created by adding two digits to the type number, that means, the number of endcut codes belonging to a certain endcut type is restricted to 100. (However, each endcut code may have any number of occurrences by variation of the explicitly given parameter(s), in the example above only the angle V.)

AVEVA Marine is delivered with a set of already defined endcut codes as specified in the standards. As an example the table below shows some of the endcut codes belonging to the endcut type 11 in Fig.1, each code with a certain combination of R1 and R2. These values can be changed by the customer as specified in paragraphs below.

Endcut type: 11

The standardized parameters of the endcut codes are set up in an endcut table, stored in the data bank associated with SB_OGDB and created and maintained by the utility program inithull.