Seam along a Line
- Last UpdatedDec 04, 2025
- 1 minute read
The seam in this case coincides with a given line.
|
<seam_along_line>::= |
|
|
( <line> (1 ... 25) [,REV] ) | <line_two_uv-points> |
|
|
[,FROM= <from_seam>] |
|
|
[,TO= <to_seam>] |
|
|
FROM/TO |
A seam within the panel at which the seam to be generated will start/end. |
|
<from_seam>::= <to_seam>::= <integer> |
|
|
The seam(s) will follow the given line(s) and may start in the intersection with another seam (FROM) and end at another seam (TO). If these are not specified, the seam is supposed to start/end at the outer contour. |
|
Note: It is not allowed to set a seam end like this:
