Structure Data Bank

1. Create the Structure Reference object.

2. Create the Hull Structure object.

3. Create the Block objects.

4. Generate the shell profile (longitudinals and transversals). In principle, Planar Hull Modelling works without them, but in practice they must be available because they are so often referred to.

5. An end cut table must be created, otherwise the end cuts in side views of stiffeners will not be correctly drawn. The end cut table is normally copied from another project.

6. Objects must be established for definition of swedging, shrinkage,

7. The gentab object contains frame positions, longitudinal and transversal coordinate limits and the midship position of longitudinals.

The above items are supported by INITHULL, except for 4. which is made in Curved Hull.